60 Vette

Corvette Trader Inc..gif (2707 bytes)





1965 CORVETTE WISCONSIN
 
 
 
 
 
 
 
 
 
 
 

1965 Corvette Coupe Resto Mod Channeled frame made by Southeast frame that accepts a C4 suspension and a LS1 and 4L60E transmission.
The suspension is from an 1986 Vette with a rebuilt Dana 36 and the rear half shafts were narrowed 4in as to not flair the rear wheel wells. It has QA1 coil over shock so it is a true 4 wheel independant suspension. The front has a Custom built Rack and Pinion. Under the body truck spray on bed liner was done under the entire body

The motor is a LS1 and an 4L60E automatic transmission out of a 1998 Camero with about 35 thousand miles on it. The Gas tank is a Rock Valley stainless 20 gallon tank. I moved up the rear inner panel so I could add the larger Gas Tank. It has stainless brake lines. The Power booster is stainless and the Master brake cylinder is Aluminum. The raditor is aluminum custom made by Dewitts. Headlight motors and the wiper motors have been rebuilt. The Coil covers were special made and painted to match the car. The steering column is a flamming River Tilt, Telescopic and Stainless. Has Cruise control. The air and heater is fron Old Air and work off of Servo\'s not cables. The Gauges are Classic Intruments and are electronic. The stereo system is 4 speakers with a 200watt amp, AM/FM CD with a Ipod cord the stereo works off a remote. The seats are out of a 2000 Corvette and are 6 way power with double Lumbar. Power windows. Has a 67 big block hood. I had the paint matched to an original 67 Corvette Silver when you get closer you see the metallic in the paint. Tinted windows. Everything on the car is new or has been rebuilt. The wheels are American Racing Torq Thrust 16 in. The rears are 9.5 wide the fronts are 8in wide. The frame is adjustable up to 2in and the coil overs also. I has a clear plastic installed on the front and behind all of the wheels so nothing would chip the paint. It Ceramic coated Headers that go to Stainless pipes that connect to Factor 2.5 in side pipes. The car was completed in April of 2010 and has 800 miles on it you can drive it anywhere!
I have complete record of every item purchased for this vehicle and pictures of the entire process
Asking 108,000.00

Call 262-968-5617  5PM to 8PM CST or Email
vette4274speed@yahoo.com

 

 

Updated   2-21-12

 

00cor.jpg (21696 bytes)

Copyright © 1998-2010 Corvette Trader Inc.


This Site is not associated with nor endorsed by General Motors ©
CORVETTE is a registered trademark of the Chevrolet Motor Division, General Motors